home // Car Information // Mazda
M az da 3 ( 4-door ) Hood QuickLIFT Mazda 3 (4 door SEDAN ...
Source: www.redlinetuning.com
File Size: 3234.92 KB
Category: Car Information
Last Download : 16 hours 19 minutes ago
Share this info:
Short Description: Step 3 - Mark centerline of hood bracket location. M. az. da 3. (. 4-door. ) Hood QuickLIFT. Mazda 3 (4 door SEDAN). QuickLIFT Installation Guide ...
Content Inside: This manual is property of Redline Tuning LLC. Any unauthorized duplication or use Mazda Manual Rev. without written permission from Redline Tuning LLC, violates Copyright laws. 3 1.01 Copyright © 2003 Redline Tuning LLC. All Rights Reserved. 2/09/06 (4door) Mazda 3 (4 door SEDAN) QuickLIFT Installation Guide Step 1 - Unpack QuickLIFT kit and verify contents. Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs (RT-QL-200-7A) - Be sure to cycle them a few times before installing. * (8) 3/16" Multi-grip Rivets - #1 Short MG. * (2) Large steel brackets - fender * (2) Small steel brackets - hood * Printed Color Instructions * Gas Spring Locking clips - (Already installed in the gas spring ball ends - Remove before assembly) Step 2 - Gather the required tools. Please gather the following tools before you begin the installation: * Power Drill * 3/16" or indexed #11 drill bits * Fine permanent marker or felt tip pen * Tape Measure or ruler * Masking Tape * Hammer & center punch * Rivet gun, capable of 3/16" rivets (most brands can Recommended: Craftsman standard or handle this size) Swivel Riveter (shown - 974749) - $9.99 to $17.99 Note: Only use the rivets supplied in the QuickLIFT kit. Step 3 - Mark centerline of hood bracket location. A. Leave your hood closed. B. Using a piece of masking tape and a permanent marker, carefully measure from the hood's corner (near windshield) and measure along the fender line. Wrap the end of the tape measure over the corner lip and place a mark on the hood masking tape at 23 -1/2". ) Hood QuickLIFT This mark will be used to align the centerline of the bracket's ball- stud in the next step. ( 4-door da 3 az M
