home // Computer // Modem
Viking Modem Quick Installation (PDF)
Source: www.vikingcomponents.com
File Size: 410.51 KB
Page: 2 pages
Category: Computer
Last Download : 34 days 22 hours 59 minutes ago
Share this info:
Short Description: Once the driver installation is done, click the “Quit” button to leave the installer. ... Your MacComCenter software installation is now complete. ...
Content Inside: QUICK INSTALLATION GUIDE
SOFTWARE INSTALLATION Mac OS 8.5 or Later Driver Software
1. Insert the "Viking Modem Companion Software" CD into your computer's CD-ROM drive. Once the CD appears on your system's desktop, double-click on its icon to open. Locate the "Viking Modem Installer" icon on the CD and double-click on it to launch. Note: If the CD was not included or lost, the drivers can be downloaded from our Web site at: www.vikingcomponents.com 3. Select "Viking 56K USB Modem" by clicking on its button. Then click the "Install" button to begin the driver installation.
VIKING COMPONENTS 56K USB MODEM (MAC OS 8.5 or Later)
HARDWARE INSTALLATION
Warning: The phone jack you use must be for an analog phone line. If you are in an office building, it may use digital phone lines. If you are not sure of the type of phone lines your office building has, contact your phone system administrator. 1. Rest the modem on its side. Locate the two phone cord jacks toward the center of the bottom panel. These jacks are interchangeable when connecting the modem to a wall jack and a phone. Plug one end of a phone cord into one of the jacks and the other end to the phone jack located on the wall. If you wish to use your modem and phone through the same wall phone jack, plug the cord from your phone into the remaining jack on the modem. Note: You can not use the phone and the modem at the same time if they share the same phone line. 2. Return the modem right side up and feed the phone cables through the back of its base. 3. Power on your computer. 4. Locate an available USB port on your computer and connect it with the USB cable on the back of the modem. This port is usually located on the back of your system. If you are not familiar with the location of the USB ports on your computer, please refer to your systems "Owner's Guide" for detailed instructions. Note: The Viking Components USB modem must be connected to a USB port on your computer or to a powered USB hub. Your hardware setup in now complete. To complete the setup of your modem, please proceed to the section "Software Installation" in this guide.
4. Once the driver installation is done, click the "Quit" button to leave the installer. 5. Click the "Restart" button to restart your system. 6. From the Apple ( ) menu, select "Control Panel" and then choose "Modem." Next to "Connect via:" the "USB Rockwell Modem" should be listed. Locate the "Modem:" pop-up menu in the "Setup" section. If your Internet Service Provider (ISP) supports 56KFlex and V.90, select "Viking 56k_v90." For ISP's that only support 56KFlex, select "Viking force 56kflex." Then close the "Modem" control panel and click the "Save" button.
Your driver installation is now complete.
MacComCenter Communication Software
1. Insert the "Viking Modem Companion Software" CD in your computer's CD-ROM drive. Once the CD appears on your system's desktop, double-click on its icon to open. Locate the "MacComCenter" icon on the CD and double-click on it to launch.
2
1
Advertiser
