home // Car Information // BMW
BMW DIAGNOSTIC TROUBLE CODES
Source: www.e38.org
File Size: 305.03 KB
Category: Car Information
Last Download : 09 hours 08 minutes ago
Share this info:
Short Description: DIAGNOSTIC TROUBLE CODES. (DTC). All 1989-94 BMW vehicles are equipped with a self diagnostic system for the detection of injection faults. When a fault ...
Content Inside: bmwcodes http://www.baumtools.com/bmwcodes.htm BMW DIAGNOSTIC TROUBLE CODES (DTC) All 1989-94 BMW vehicles are equipped with a self diagnostic system for the detection of injection faults. When a fault is detected by the system the Electronic Control Unit (ECU) records the code corresponding to the defect in the ECU's memory until either: MOTRONIC 'PEDAL' FAULT CODES (CARB) MOTRONIC INTERNAL TROUBLE CODES DME 1.1, 1.2, 1.3 DME 1.7, 1.7.1 & 3.1 DME1.7.2 DME 3.3 DME 3.3.1 DME MS40 DDE 1 DDE 2 SUPPLEMENTAL RESTRAINT SYSTEM (AIRBAG) CODES SRS 1 SRS 2 SRS 3 SPECIAL NOTE ON E24 & E30 SRS SYSTEMS ELECTRONIC TRANSMISSION CODES EGS 1.XX EGS 1.XX Late Model EGS 2.28 EGS 4.XX EGS 7.XX EGS 9.XX BMW MOTRONIC 'PEDAL' FAULT CODES (Models 1989-94) All 1989-94 BMW vehicles are equipped with a self diagnostic system for the detection of injection faults. When a fault is detected by the system the Electronic Control Unit (ECU) records the code corresponding to the defect in the ECU's memory until either: 1) The vehicle battery or the ECU is disconnected. 2) The engine is started 60 times with no recurrence of the fault. 3) The ECU memory is cleared using the Bosch KTS300, CARSOFT BMW software or the CS1000 BMW hand scanner. To review the FAULT CODES from the ECU memory use the following procedure: 1) Turn the ignition switch to the 'engine run' position. 2) Depress the gas pedal to the floor 5 times. 1 of 32 11/15/00 9:55 AM
